Tomorrow is my pre-solo stage check, second attempt (second go around). I literally had to “go around” after my first landing at French Valley on the last stage check. I landed hard, and bounced. Fortunately, it wasn’t too disastrous, and the only thing that got hurt was my pride. But it definitely wasn’t a safe landing, and I realized I needed some more practice. I’ve had three lessons with my new CFI Andy, and tomorrow is the redo of the practical test portion. Tonight I’m reviewing maneuvers, stalls, slow flight, landings, and emergency procedures. Basically, I needed to be prepared for everything, because the next step is the solo flight.
Inflight Emergency Engine Failure – the ABC’s
I know from reading my Pilot Operating Handbook / Information Manual, that with proper preflight inspections and maintenance, inflight emergencies caused by aircraft or engine malfunction are extremely rare. Still, it’s important to know what to do, because my life is at stake, as well as the lives of my passengers and people on the ground. It’s easy to recite a list of procedures on the ground, but it’s harder to remember everything when it’s actually happening. That’s why we have acronyms, and checklists.
A=AIRSPEED (Best Glide Speed – 65 KIAS). Pitch and maintain so as to stay aloft as long as possible.
B=BEST LANDING AREA. Look for a safe, flat and level area to land, keeping in mind that it may be underneath you or behind you. Immediately start heading towards that area and commit to it
C= CHECKLIST. This is situation permitting. If you are 500 feet above ground, you may not have time to pull out your checklist. But if you are 4,000 feet in the air, you should attempt an engine restart if possible. I learned to use the “7-UP Checklist”, start at the bottom and think of the shape of the number “7”.
Fuel Shutoff Valve – On
Fuel Selector – Both
Mixture – Full Rich
Throttle – Power Set
Master – On
Aux Fuel Pump – On
Ignition – Start
Assuming the engine does not restart, Squawk 7700 and make a Mayday call on 121.5. Do not add flaps until you know you have the field made. Here is a video that I found helpful:
Leave a Reply